We don't have any photos of this building yet. Why don't you be the first to send us one?
Latitude: 50.9499 / 50°56'59"N
Longitude: 0.7322 / 0°43'55"E
OS Eastings: 592007
OS Northings: 120274
OS Grid: TQ920202
Mapcode National: GBR QXP.CXD
Mapcode Global: FRA D6FL.M2H
Plus Code: 9F22WPXJ+XV
Entry Name: 5 and 6, Mermaid Street
Listing Date: 12 October 1951
Grade: II
Source: Historic England
Source ID: 1251938
English Heritage Legacy ID: 434839
ID on this website: 101251938
Location: Rye, Rother, East Sussex, TN31
County: East Sussex
District: Rother
Civil Parish: Rye
Built-Up Area: Rye
Traditional County: Sussex
Lieutenancy Area (Ceremonial County): East Sussex
Church of England Parish: Rye
Church of England Diocese: Chichester
Tagged with: Building
TQ 9120
TQ 9220
MERMAID STREET
(south side)
1/111
Nos 5 & 6
12.10.51
GV II
House, subdivided into two properties at one time. C15 front range with C17 inserted floor and C16 rear wing, restored in the 1920s. Timberframed with plaster infill, brick to the east wall and part of the ground floor of the rear wing. Tiled roof half-hipped to the east with brick chimneystack. Two storeys and attics, irregular fenestration of early C20 metal casements with leaded lights.
PLAN: Front range has two bays of a continuous jetty house, possibly originally an open hall, which may have extended further to the east or west with later L-wing to the south west.
EXTERIOR: The north or street front has a continuous jetty which is close-studded to the first floor, the ground floor also close-studded with imported curved beam and upright post to the left hand side. Gabled early C20 dormer, the first floor has two three-light and a single light casement and the ground floor one two-light and one four-light large mullioned and transomed casement. Wooden double door of four deep panels each side of early C18 date and imported. Part of an ornamental pump has been reused as a water spout. The east elevation is of brick to the top of the first floor and the attic has a timberframed wall of very thin scantling. The rear or south elevation also has close-studding to the first floor, is plastered and has a three-light casement window. The south west wing has a timberframed upper floor with three casements and a part brick, part timberframed ground floor. Part of an ornamental lead pump has been reused as a water spout.
INTERIOR: The ground floor north room has a ceiling with C17 axial beams and floor joists and south partition wall. There is an open fireplace to the east with a wooden bressumer of early C18 date but built-in cupboards on either side which are architectural salvage. A wooden cupboard in the south western corner appears to be of French C18 date. The south ground floor room to the main range has C17 axial beams and floor joists. The lounge in the rear wing has a replaced axial beam but some of the wall frame, including a curved brace to the western wall, is original. The open fireplace has a C16 wooden bressumer although the brickwork is early C20. Access to the upper floor is by a half-winder staircase with introduced elaborate turned balusters. The first floor eastern bedroom has two substantial tie beams with jowled posts, one with curved tension braces. The cupboards with plank doors were installed in the early C20. The western bedroom has curved braces to the western wall. The upper floor of the rear wing has been restored with a series of bolted knees added to the frame of the west wall. Some of the frame is of thin scantling and a fireplace to the south has a wooden bressumer but early C20 brickwork. The attic storey of the front range has two tall square section crownposts with head braces, collar beams and sans-purlin rafters.
HISTORY: A C15 continous jetty building of two bays, perhaps originally with open
hall, with C17 inserted floor and C16 rear wing. In the C18 it was underbuilt on the ground floor to provide more room and refronted in brickwork and is shown in this condition in a photograph of circa 1900. In the 1920s the owner of the Mermaid Inn opposite, a Mr Blythe, purchased this building and removed the brick front to expose the timberframing, repaired the building with old timbers from elsewhere, imported old fittings and replaced all windows in metal framed casements with leaded lights. These works had been completed by 1937 as they are recorded in "Victoria County History Volume IX, published in that year. The building is shown on the First Edition Ordnance Survey map and on the 1904 and 1919 editions the building appears to be divided into two properties.
SOURCES:
Pevsner and Nairn "Buildings of England. Sussex." Reprinted 1985. Page 598.
"Victoria County History. Volume IX." Page 48.
SUMMARY OF IMPORTANCE
An inspection has demonstrated that this is a timberframed building dating from the C15 and therefore of considerable architectural interest. During the 1920s restoration an C18 front was removed, and salvaged architectural fittings added. The building retains a substantial part of its original fabric, including front range first floor exterior walls, ceiling beams, partition walls and crownposts. It also forms part of a group of listed buildings within the Rye Conservation area.
Listing NGR: TQ9200720271
External links are from the relevant listing authority and, where applicable, Wikidata. Wikidata IDs may be related buildings as well as this specific building. If you want to add or update a link, you will need to do so by editing the Wikidata entry.
Other nearby listed buildings